# Hub 2.0 doesn't show altitude in simulation mode

**URL:** <https://forum.flylitchi.com/t/hub-2-0-doesnt-show-altitude-in-simulation-mode/28295>\
**Category:** General Discussion\
**Tags:** litchi-hub\
**Created:** [May 5, 2026, 3:51pm UTC](https://forum.flylitchi.com/t/hub-2-0-doesnt-show-altitude-in-simulation-mode/28295 "2026-05-05T15:51:32Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![William\_Shelley](https://forum.flylitchi.com/letter_avatar_proxy/v4/letter/w/eb9ed0/32.png) [@William\_Shelley](https://forum.flylitchi.com/u/William_Shelley)\
**Post date:** [May 5, 2026, 3:51pm UTC](https://forum.flylitchi.com/t/hub-2-0-doesnt-show-altitude-in-simulation-mode/28295/1 "2026-05-05T15:51:33Z")

</div>

Hub 2.0 in simulation mode reports drone altitude as zero:

 ![litchihub](https://forum.flylitchi.com/uploads/default/original/2X/9/9b330d4ff85db5f7163f5eb8170b06001cde1030.jpeg)

If you stop the simulation, it shows altitude:

 ![litchihub2](https://forum.flylitchi.com/uploads/default/original/2X/2/2475124b1000577f056483e537051b6964d216eb.jpeg)

Since DJI’s “smooth curves” implementation creates elevation under- and over-shoots at waypoints, this lack of visual information could cause trouble.

It was convenient to run the simulator and watch the altitude to ensure the drone doesn’t get to close to something. Now I must stop the simulator to find the altitude at any given point in the mission.

Is there a setting to restore this data display during simulation?

---

<div class="post-metadata">

**Author:** ![vico](https://forum.flylitchi.com/user_avatar/forum.flylitchi.com/vico/32/24_2.png) [@vico](https://forum.flylitchi.com/u/vico)\
**Post date:** [May 6, 2026, 1:00pm UTC](https://forum.flylitchi.com/t/hub-2-0-doesnt-show-altitude-in-simulation-mode/28295/2 "2026-05-06T13:00:15Z")

</div>

It should be fixed now, thanks for reporting the issue